Continuity Tester

4.9 star rating 129 Reviews

The purpose of the tester is to verify that your Earthing Product is conductive. It contains two replaceable batteries.

1. Insert Safe T Cube into grounded outlet or ground rod cord.

2. Plug Earthing cord from mat into one of the two Safe T Cube Ports.

3. Insert prong end of tester cord into the other Safe T Cube port.

4. Place product tester flat on your earthing product. The round metal plate must be in contact with surface of mat or sheet. Press firmly on the material to obtain a good contact. A green light means that mat is in working order. In unlikely case that no green light comes on, the mat may be defective or has lost conductivity and should be replaced. Sometimes, people have difficulty testing their product. If the light doesn’t come on, place one hand on the conductive side of the material while holding the tester in the other hand and with one finger on the silver button on back of tester. A green light would show that the body is grounded when touching the sheet. Make sure that both the tester and the product are plugged in to the ground, as described above. The reason for perhaps the light not going on: you aren't pressing hard enough on the tester. The material sometimes prevents the button from contacting the conductive  fibers of the product. The surface seems smooth, but if you were to look at it with a microscope you would see "hills and valleys." The pliant surface of the skin, unlike the hard metal button, will bend around fibers and make good contact. You can also put some moisture on your finger tips to create a better contact.

5. Disconnect tester from the ground connection, then disconnect the tester cord from the Safe T Cube.

6. You don’t have to test your product often. Perhaps after cleaning. The more you use the tester, the sooner the batteries in the tester will expire.

include usage is not allowed in this context